Motorcycle Cannonball Forums / The Motorcycle Cannonball Run / The Cannonball v / Lathe Question

Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Lathe Question
04-28-2012, 10:39 AM
Post: #1
Buck Carson Offline
"Confirmed Cannonballer"
 		Posts: 16
Joined: Dec 2011
Reputation: 0
Lathe Question
Hi everyone-

Wasn't sure where to post this, so here goes..

I'm currently outfitting the team's race trailer for the Cannonball. I'm shopping for a lathe to install. Can anyone tell me what size the other lathe was that was on CB 1?
"It is not the man who makes the journey, but the journey who makes the man." - Unknown

Buck Carson
Carson Classic Motors Race Team
Rider Number 3, 1927 BSA single
Find all posts by this user
Quote this message in a reply
05-03-2012, 07:26 AM
Post: #2
FatDog Racing Offline
"Confirmed Cannonballer"
 		Posts: 140
Joined: Sep 2009
Reputation: 0
RE: Lathe Question
(04-28-2012 10:39 AM)Buck Carson Wrote:  Hi everyone-

Wasn't sure where to post this, so here goes..

I'm currently outfitting the team's race trailer for the Cannonball. I'm shopping for a lathe to install. Can anyone tell me what size the other lathe was that was on CB 1?

Joh Szlay had his own small lathe, and I am not sure of the make, we a had a small Atlas-Clausing. Nice rig!
FatDog Racing No.33
http://www.fatdogracing.blogspot.com
http://www.fatdogvintagesalvage.com
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


Contact Us | Motorcycle Cannonball | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication